Keri Systems EntraGuard Platinum Quick Start - Manual (Page 25)

EntraGuard
®
Platinum Telephone Entry Controller
Quick Start Guide
Page 25 of 28 P/N: 01969-001 Rev. C
Figure 32: Clear Memory
From the Clear Memory Screen you may either:
1. Press 1 to clear the controller’s RAM. The LCD will change to show the memory is being cleared (see Figure 33).
Once the controller’s RAM has been cleared, the unit is ready for use. The LCD will rotate between the Initialization
Warning and EntraGuard Default screens (see Figure 30 on page 24 and Figure 31 on page 24) until a Total Update
from Doors has been performed on the unit.
Figure 33: Clearing Memory
OR
2. Press 2 to return to the Reset Menu without clearing the controller’s RAM.
NOTE: Clearing the system RAM completely erases all information within the EntraGuard Platinum controller, except for
the controller address. If there is any information in system RAM from an access control installation and the system RAM
is cleared, the information in the controller is lost and cannot be recovered.
8.3 Set Microphone Volume
The EntraGuard controller comes with the microphone gain set for proper operation. The Set Microphone Vol menu
option is not used at this time.
8.4 Diagnostics and Troubleshooting
For information regarding the diagnostics screens and troubleshooting the EntraGuard Platinum Controller, see the
EntraGuard Troubleshooting and Diagnostics Guide (P/N 01912-001).