Fcc compliance statement, Canadian compliance statement – Kindle Touch 3G User Manual

Page 32

background image

Kindle User’s Guide


Appendix A Product Information

In addition, turn off and do not charge your device if you are in any area with a potentially
explosive atmosphere, as sparks in such areas could cause an explosion or fire. Such areas
are usually, but not always, clearly identified, and include areas where you would normally be
advised to turn off your vehicle engine.

FCC Compliance Statement

Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is


• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

Information Regarding Exposure to Radio Frequency Energy

Your Device is designed and manufactured not to exceed the emission limits for exposure
to RF energy set by the Federal Communications Commission of the United States (FCC).
Information on your Device is on file with the FCC and can be found under the Display Grant
section of


after searching on the FCC ID for your Device,

which can be found on the back of the Device.

Canadian Compliance Statement

This device complies with the Canadian ICES-003 Class B specifications.

This device complies with RSS 210 of Industry Canada. This Class B device meets all the
requirements of the Canadian interference-causing equipment regulations.

This device complies with Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions:

1. this device may not cause interference, and

2. this device must accept any interference, including interference that may cause undesired

operation of the device.

This device is compliant with general population/uncontrolled RF exposure limits in IC RSS-

This manual is related to the following products: