Kurgo Wander Cargo Barrier - Manual

INSTALLATION & CARE
To Install Barrier in Your Vehicle:
Securing screws - x12
Crossbar clips - x12
Crossbar end pieces - x6
Leg wing nut adjusters - x2
Crossbar connectors - x6
Legs - x2
Leg extenders - x2
Treaded rubber
feet (bottom) - x2
Treaded rubber
feet (top) - x2
1. Ensure the intended installation area is clean and free of
obstruction. Do not install on parcel shelf or other
non-permanent structure.
2. Place the barrier in the back of the car, and expand the Legs
upwards until they extend from the floor to the roof.
3. Once the barrier is wedged in place, tighten the wing nut
adjusters (f) to secure. To micro-adjust for a sturdier fit,
twist the bottom leg knobs (j) counter-clockwise.
4. With the Legs now installed, move the Crossbars up or down to create the barrier between the car seating area
and the car trunk. You can also adjust the width by pulling on the crossbar endpieces (d).
5. Tighten the securing screws (g) with a screwdriver to fix the Crossbars in place.
Crossbars
Legs
NOTICE:
Please contact Kurgo directly with any product or return inquiries. If you have any questions or conerns please contact
us directly before you contact the retailer; we are great problem solvers. We hope that you will be happy with your
purchase and will think of Kurgo next time you travel with your dog.
Kurgo Products • 2D Fanaras Drive, Salisbury, MA 01952 • 877-847-3868 • kurgo.com • [email protected]
See the complete line of
dog travel products at kurgo.com
Become a fan of Kurgo on
Facebook and receive all the latest
updates, giveaways and contests.
01/14 ~ English
Pieces Included:
d
e
f
f
g
j
d
d
g
h
i
c
b
a
Crossbar connectors
Snap on crossbar clips (e)
End pieces +
1. To Assemble Crossbars:
2. To Assemble Barrier:
Screws (g) go in each crossbar clip (e)
(Do not tighten yet)
(Screw holes should be facing inwards)
Affix the treaded rubber
tops (i) and bottoms (h)
to each leg piece
Tighten wing
nut adjuster
just enough to
hold the two
pieces together
Insert the
ends of the
leg (b) and
leg extender
(c) into the
wing nut
adjuster (f)
*Make sure the
wing nut adjuster
screw is fitted
into the leg
extender’s hole
d
e
f
f
g
h h
i i
e
c
b
a
Slide legs through the crossbar clips (e) on the three
crossbars. Space out evenly.