Kurgo Skybox Booster Seat - Manual

5-11
A D-ring / Anneau en D
B Leash hook / Laisse
C Nested Buckles™ / Niché Buckles
D Lower Straps / Sangles inférieures
E Padded Chest Plate / Plastron
F Upper Straps / Sangles supérieures
Installation & care
Headrest Strap
Headrest Strap Adjuster
Headrest Strap Clips
Seat Back Strap
Harness Tether Headrest Strap
Headrest Strap Adjuster
Headrest Strap Clips
Seat Back Strap
Harness Tether
KEY: KEY: INSTALLATION IN VEHICLE:
1. Buckle the seat belt where the booster seat will be installed.
Clip Headrest Strap (a) to Headrest Strap Clips (c) on
headrest. Use the Strap Adjuster (b) to select a suitable
height for your Skybox.
2. Wrap Seat back Strap (d) around the back of the seat and
(e) once Fido is attached you are ready to roll.
INSTALLATION IN VEHICLE WITHOUT HEADREST:
1. Buckle the seat belt where the booster seat will be installed.
Clip Headrest Strap (a) to Headrest Strap Clips (c) on sides
Extend the length of the Headrest Strap (a) so the bottom
of Skybox Booster Seat rests on seat.
2. Wrap Seat back Strap (d) around the back of the seat and
(e) once Fido is attached you are ready to roll.
Check with vehicle manufacturer
for air bag guidelines.
BASIC SETUP
1. Place bottom of U-shaped steel support brace into the bottom back of of the Skybox frame under the removable
liner, with the two ends facing up and toward the front at a 45º angle. (image 1)
2. Place ends of U-shape steel support through button holes at the top front of the Skybox frame, inside each of these holes is a
the metal buckle for securing Skybox Tether (e) pulls through and one on each side for the Headrest Strap (a) to attach.
4. Place reversible Quilted Seat Pad in the bottom, on top of the liner.
4 5
2 3 1