LABEC GW1060 - Manual (Page 12)

Rev. 00 GW2045 – GW1060 Manual Pag. 11 di 43
4.2. LIFTING AND HANDLING
Before it leaves the factory, the base of the machine is fixed to a pallet which is then
used to lift and transport the machine itself.
The machine must be handled with a fork-lift truck or transpallet.
Do not use appliances damaged by transport! Consult your dealer if in doubt.
The appliance must only be installed and connected by personnel authorized by the
manufacturer.
4.3. DOOR-LOCKING SYSTEM
After unpacking, pay attention to the following: the machine is equipped with an automatic door
locking/unlocking system. The door is locked.
Don’t force the door, but follow the procedure below.
• Connect the machine to the mains supply;
• push the ON/OFF button (in order to switch on the machine)
• Press the button that has the KEY symbol on it: The door will open automatically after a few
moments.
SIGNS ON THE FRONT OF THE MACHINE
Door unlocking ON / OFF
°C Temperature Salt Lack
► ll START / PAUSE HEATING ELEMENT ON
In order to open the door without connecting the machine to the mains, the manual unlocking procedure
must be executed (see section below).
fig. 1 – Front of the GW2045. To unlock the door it is necessary to: Turn on the machine (ON/OFF symbol), 2 – Press the button with
the KEY symbol (first button on left) and wait a few seconds.