LABEC GW1060 - Manual (Page 40)

Rev. 00 GW2045 – GW1060 Manual Pag. 39 di 43
9. CLEANING AND MAINTENANCE
Electric Power supply
Disconnect the power supply before any intervention, using the panel knife switch or
disconnect the power cable, and shut off the water tap. If any damaged electrical cables
need replacing, it is necessary to use HT 105°C cab les (high temperature) or H05V2-K
5
.
FREE SPACE
It is necessary to have about 1m2 of free space in front of the machine to be able to work
correctly.
DETERGENTS
Pay special attention when handling the detergents, for safety instructions, read
paragraph 7.6.
9.1. RECOMMENDATIONS
AND GENERAL ADVICE
General cleaning
The external surfaces and door frame of the glassware washer must be cleaned at regular intervals with a
soft cloth soaked in water or a normal detergent for steel surfaces.
The door seals must be cleaned with a damp sponge.
It is advisable to clean off any dirt that may have accumulated in the washing chamber or on the seals every
so often (once or twice a year) using a soft cloth and water.
fig. 17 – inlet water filter "A"
How to clean the water inlet filter
Water inlet filter A installed at the cock outlet must be periodically cleaned. First shut off the supply cock,
then unscrew the end of the water fill plug, remove the filter A and clean it delicately under running water. Fit
filter A back in its housing and carefully retighten the water fill pipe.
How to clean the spray arms
The spray arms can be easily removed so that the nozzles can be periodically cleaned to prevent clogging.
Wash them under running water and then fit them back in their housings. Make sure that their circular
movement is not hindered in any way.
5 H05V2-K, according to the nomination abbreviations on cables:
"H": Harmonised with brand “HAR”.
"05": Nominal voltage U
0
/U 300/500V.
"V2": PVC for temperature of 90°C.
"-K": Flexible cable for fixed laying.