Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 11)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
11
7. LCD display will read “Zero point set successfully” once
process is complete (Fig. 19).
Fig. 19
Unhitching from Tow Vehicle
NOTE: Prior to unhitching from the tow vehicle, ensure unit is
parked on a level surface and be sure to chock the tires of
the unit.
1. Extend the inner legs of both landing gear 4-5 inches by
pulling on the quick release pins.
2. Push “ON/OFF” (Fig. 20A). LCD Screen will light up and
display “READY JACKS: UP” (Fig. 20B).
3. Push the “UP” arrow (Fig. 20C) to scroll to “Drop Front
Jacks” option on LCD screen.
NOTE: Red indicator lights (Fig. 20D) may come on,
indicating the current disposition of the unit. In this case,
the front and right sides of the unit are low.
4. Push “ENTER” (Fig. 20E). Both front landing gear jacks will
go to ground and stop.
5. Push the “FRONT” button (Fig. 20F) extending the front
landing gear to a sufficient height, which raises the front of
the unit off of the tow vehicle’s 5th wheel hitch plate.
6. Pull tow vehicle away and park at a safe distance.
Fig. 20
A
B
D
D
C
E
F
6. LCD display will read “Zero point stability check” (Fig. 18).
Fig. 18
8. The system will set this point as its level state and the touch
pad will turn off.