Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 4)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
4
Installation - Rear Jacks
(Fig. 3)
NOTE: For this portion of the installation, use parts A, B, D,
G, H, K, W, and Y on the parts list. L is referenced but
not needed.
1. Determine position and ground clearance requirements for
the rear jacks (A, B). The rear jack brackets (D) should be
mounted approximately 1 foot behind the rear tires and be
aligned with each other.
NOTE: When fully retracted, rear jacks should maintain
7 – 9 inches of ground clearance.
2. Mark jack mounting bracket (D) locations on the main
frame rail.
3. Using a 5/16” drill bit, drill through the frame at the
marked positions.
4. Using the included self-tapping bolts (K), mount the
brackets to the frame. Tighten the bolts to no more than
75 lb.-ft. of torque.
6. Bolt the rear jacks (A,B) to the mounting brackets
(D) using six bolts (G) and nuts (H) per jack. Tighten the
bolts to 90 lb.-ft. of torque.
7. Connect the wire harnesses (W and Y) to the rear jack
motor wires and run the harnesses to the compartment
where the controller (L) will be mounted.
NOTE: LCI recommends zip-tying the harnesses tight against
the rear jack motors to prevent damage to the harnesses.
Fig. 3
main frame rail
jack mounting
bracket
jack
bracket
bolt
jack mounting nut
jack mounting bolt
rear jack