Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 12)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
12
Auto Level
1. After unhitching from tow vehicle, and parking the vehicle
at a safe distance away from the unit, press the “ON/OFF”
button (Fig. 21A) and then press “AUTO LEVEL” (Fig. 21B).
Fig. 21
A
B
NOTE: Once the automatic leveling cycle has been started, it
is important that there is no movement in the coach until
the unit has completed the leveling process. Failure to
remain still during the leveling cycle could have an effect
on the performance of the leveling system.
NOTE: In order for hitch recognition feature to function, the
auto level sequence must be started with the front of the
unit above level.
Auto Level Sequence
1. When Auto Level Sequence begins, the front of the unit will
lower slightly to a point below level. The coach will then
stop and raise up to the point where it is level from front to
rear.
2. Rear leveling jacks are grounded.
3. A side to side leveling sequence occurs.
4. Each jack will perform a final grounding touch.
5. LCD will read “AUTO LEVEL SUCCESS” (Fig. 22).
6. LCD will then read “READY Jacks: Down” (Fig. 23A), and
Fig. 22
Fig. 23
the green LED at the center of the four jack buttons will be
illuminated (Fig. 23B).
NOTE:If the AUTO LEVEL sequence does not perform as
described, place the system in the manual mode and
test that the jacks operate correctly by pushing their
coordinating buttons on the touch pad; i.e. FRONT button
operates only the front jacks.
A
B