Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 14)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
14
Fig. 29
Fig. 30 Fig. 31
Fig. 32
port
Confi guring the Remote
Fig. 34
Fig. 33
B
A
A
1. Turn the remote on by pressing and releasing the large silver button
at the bottom of the unit (Fig. 33A). If the remote has never been
confi gured, it will display the Confi guration button immediately after it is
turned on. To access the Confi guration button after the initial program-
ming, push the silver button 5 times.
2. Press the “Confi g” button on the touch screen to begin confi guring
the remote (Fig. 34A).
1. Find the port on the bottom of the jack motor (Fig. 29).
2. Remove the rubber plug (Fig. 30).
3. Insert the
5 / 16 ” socket into the port (Fig. 31).
4. Turn override until the jack extends or retracts to desired
position (Fig. 32).
Manual Override Procedure
BOTTOM Of Jack Motor
NOTE: Use of a 12V-18V cordless screw gun or pneumatic
screw gun is acceptable to manually override the jacks.
Do not use an impact screw gun to perform the override
procedure, as this may damage the motor.
Tools needed: 3 / 8 ” drive ratchet and extension, 5 / 16 ” socket