Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 13)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
13
Hitch Recognition
1. Turn on touch pad.
2. Press the left and right buttons simultaneously (Fig. 24A
and 24B).
Fig. 24
A B
3. All leveling jacks will retract first, then the landing gear will
extend to raise the unit to the height where the auto level
sequence was started.
NOTE: If the auto level sequence was started with the front of
the unit in a below-level condition, the Hitch Recognition
will not function and the LCD will display “Feature
Disabled.” In order for hitch recognition feature to function,
the auto level sequence must be started with the front of
the unit above level.
Manual Override Procedure
TOP Of Jack Motor
NOTE: Use of a 12V-18V cordless screw gun or pneumatic screw gun
is acceptable to manually override the jacks. Do not use an impact
screw gun to perform the override procedure, as this may damage
the motor.
Fig. 25
Fig. 26
Fig. 27
Fig. 28
port
NOTE: If manual override is necessary on any jack in the system,
there are two options. The following processes on the next two
pages will explain how to use the top and the bottom overrides.
Tools needed: 3 / 8 ” drive ratchet and extension (no socket)
1. Find the port on the top of the jack motor (Fig. 25).
2. Remove the rubber plug (Fig. 26).
3. Insert the
3 / 8 ” drive into the port (Fig. 27).
4. Turn override until the jack extends or retracts to desired position
(Fig. 28).