New England Arbors VA68133 - Manual (Page 3)

S T E P T W O
3
Insert the four short horizontals spindles into one long LEFT
vertical spindle, one long RIGHT vertical spindle and one short
vertical spindle that is positioned in the middle.
Lay out the horizontal bottom rail and insert three vertical
spindles.
Slide the horizontal mid-rail over the ends of the spindles.
Slide the horizontal bent top rail over the ends to complete one
side panel (ensure that bend is down).
Set out one post and complete the side panel by inserting it into
the post. Start with the bent top rail first.
Lay out the second post with holes facing upwards and insert
the completed panel with connected post into. Note that there
are Left and Right side posts as indicated with the ‘L’ and ‘R’ at
the top of the respective posts.
Repeat for other side panel.
1
The Florence Arbor
Assemble the Side Panels
2
3
4
5
6
7
1 2 3 4
6
Set out one side panel. Insert the assembled arch through
the holes at the top of the posts. Do the same for the other side
panel. You will need a helper.
Adjust the opening width to 42in. between the posts
(arbor allows for minor variance).
Fasten the arch system to the posts by installing the screws
provided into the 2-pre drilled holes per post.
Place post caps on top of posts.
1
Connect Arch System to Side Panels
2
3
4
3
S T E P T H R E E
www.edenarbors.com
NOTE: Some of the horizontal rails have locking tabs located
at both ends. Once inserted and pushed into the routered
holes, they will lock into place.
5
Insert 1st
Insert 2nd
Insert 3rd
1
‘R’
‘L’
Left
Right