New England Arbors VA68103 - Manual (Page 2)

S T E P O N E
2
Insert arches into arch keystone ensuring they terminate flush
to the internal connector. Ensure that the “R” and “L” identi-
fications are located at the bottom of the arch assembly. The tabs
protruding out of the internal connector should fit outside the arches.
Ensure that the arches are orientated properly as per illustration.
Fasten the arch system to the keystone by installing the small
(1 1/2 in./3.8 cm.) screws into the two pre-drilled holes provided.
(No predrilled holes in arches)
Invert the arch system and install two small (1 1/2 in./3.8 cm.)
screws from the bottom of the keystone into the two pre-
drilled flanges on either side of the bottom of the insert. This
will connect the bottom of the arches to the insert.
Seal the bottom hole on the keystone by inserting the bottom
plate as provided.
Install the top cap on the arch keystone. Push down firmly
so the cap locks into position.
Repeat for other arch.
Insert arch rafters (8) into the holes on the arches until they
bottom out inside the arches. There are “locking tabs” located
at each end of these rafters that once inserted into the holes
will lock into place.
Install post caps on the bottom of all arches. Slide up into
temporary position until they hit the first rafter.
The Livingston Arbor
Assemble the Arch System
1
2
3
5
www.edenarbors.com
5
4
6
7
8
Slide up to
the first rafter.
1
7
8
3 4
2
R
L
L
“R” and “L” identifications
at the bottom of the
arch assembly.