New England Arbors VA68144 - Manual (Page 3)

S T E P T W O
3
Lay out the horizontal bottom rail and insert the three long
vertical spindles.
Slide one horizontal mid-rail over the ends of the spindles
to complete the bottom panel.
Layout the other horizontal mid-rail and insert the three shorter
spindles in the pattern identified on the illustration.
Slide the horizontal bent top rail over the ends to complete
the top side panel to complete the top panel.
Set out one post and complete the side panel by inserting it into
the post. Start with the bent top rail first.
Layout the second post with holes facing upwards and insert
the completed panel and connected post into.
Fasten the horizontal bent top rail and both horizontal mid
rails to the posts by installing 6 long (3 in./7.6 cm.) screws into
posts as illustrated.
Repeat for other side panel.
1
The Vienna Arbor
Assemble the Top & Bottom Side Panels
2
3
4
5
6
7
1 2
4
5 6
Set out both side panels ensuring that bottom rail profiles
are facing outwards.
Insert the assembled arch into the top of all four posts
until the arch bottoms rest on top of the "stopper" bolts.
You will need a helper.
Pull the post caps down into final position over the posts
and fasten the arch system to the posts by installing 2 short
( 1 1/2 in. / 3.8 cm.) screws per post as illustrated.
1
Connect Arch System to Side Panels
2
3
3
S T E P T H R E E
2
3
NOTE: Some of the horizontal rails have locking tabs located
at both ends. Once inserted and pushed into the routered
holes, they will lock into place.
*
* Bottom
of Arch
A B A
Insert
1st
Insert
2nd
Insert
3rd
1
7
8