New England Arbors VA68144 - Manual (Page 4)

4
S T E P F O U R
Move the arbor to its final location (you will need a helper).
When you are satisfied with the location, mark the positions of
the posts, then move the arbor aside and lay it carefully on it’s side.
Excavate 4 holes approx 12” deep. Carefully move the arbor back
into position and level it both vertically and horizontally.
Backfill the holes with the excavated soil to cover the anchors.
1
Ground Anchors Installation
2
Complete A #1 above, with the exception of excavating the holes
at least 6” wide x 18” deep. Fill holes with wet cement within 3”
of your grade (you will need 2 bags of pre-mix concrete - purchase
separately). Carefully move the arbor back into position.
Support the arbor plumb and level over the holes with bricks,
stones or blocks of wood under the bottom rail of the side panel.
The post bottoms should insert themselves approx 1/2” into
the concrete.
1
2
Arbors must be well secured to prevent tipping over from wind load etc.
We have provided four ground anchors for securing the arbor either
into the ground or a concrete footing. In some cases it may be acceptable
to secure the arbor to an existing structure such as a fence post. If you
are installing your arbor on concrete or a deck, see your hardware
store for the appropriate galvanized bracketing hardware.
B Into Earth Without Concrete Footing
C Into Earth With Concrete Footing
Optional
If you plan on attaching a fence or bench to the arbor, or in the
event of extreme wind conditions we would not recommend
using the ground anchors provided. Consider purchasing pressure
treated lumber and trimming it down to 3 1/4 wide and cutting
it into 36” lengths. Insert into the bottom of all four posts until
they hit the bottom horizontal rail on the side panel. Fasten
accordingly with screws and install either directly into the ground
or into a concrete footing.
3605 32nd st., Building 3., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
A
B
2“ x 4” Wood Insert
(Purchase Separately)
Optional
A
Install Ground Anchors
Insert the ground anchors into each of the post until they
reach the bottom rail.
Fasten each posts with two of the provided screws as shown.
12
C
1
18
6
2