Flat top pergola pg10, Vinyl beam assembly – New England Arbors VA84045 User Manual

Page 10

Advertising
background image

110

110

Beam In

sert

Vinyl Beam Assembly

1

Insert two short steel stiffener into one long steel stiffener to

create full length piece. Repeat so you have two full length beams.

Insert the end of the vinyl beam marked ‘A’ into the joiner. Install

the joiners so that the side with the four holes are facing up.

Push firmly until the extrusion bottoms out inside the joiner.

Please Note:

Ensure to orientate the main beams correctly so the pre-drilled

holes for future installation of rafter brackets is correct.

Insert one assembled steel stiffener (with steel block facing up),

into the lower pocket of the vinyl beam past the joiner. Push

until steel block hits the internal ribbing.

Slide the other end of vinyl beam marked ‘A’ over the steel insert

and into the joiner.

Screw the joiner to vinyl beams and steel insert using 1 1/2”

screws. The bottom and top holes will need to be pre-drilled

(use drill bit provided).

Install the rafter brackets to the main beams using 5/8”

screws. Follow the pre-drilled holes to identify locations.

1

2

3

S T E P F O U R

4

5

2

10

10 x 10 Flat Top Pergola

3

5

6

6

Four holes facing up

4

Pre-drill holes on bottom and top to

accomodate for internal steel stiffener.

At this stage, the columns should be properly

installed as per the following illustration,

with the columns 110” apart.

Also, notice that the holes at the top of each

post should be facing the same direction.

Beam In

sert

Beam In

sert

Beam In

sert

Beam In

sert

Beam In

sert

Bea

Steel block should face up

A

A

A

Note:

If you have base molding on your

posts, measure above moldings as the
measurement is to be from post to post.

www.newenglandarbors.com

Advertising