New England Arbors VA84045 - Manual (Page 18)

Privacy Fence Panel
Assembly & Installation
S T E P O N E
18 The Privacy Fence Panel
Install Fence
Install post bracket on one end of the bottom rail using
5/8” screws provided.
Slide the opposite end of the bottom rail into the routed
hole on the post.
Using a level mark the position of the bracket on the opposite
post and screw bracket into place.
(continued on following page...)
1
S T E P T W O
2
3
2 3
1
1
2
3
55“
String Line
55“
Note: As mentioned on page 9, wall is not designed to fit pergola
with base mold as custom cutting of pieces will be required.
Install the Middle Post
Measure and mark out the location of the wood 4x4 post using
string or chalk line. Center of 4x4 wood post should be located
between two pergola columns.
Please Note:
Follow the same applicable post instruction method as illustrated
on pages 7 or 8 of this instruction guide.
Using the vinyl weld glue insert the One Way 4”x4” Internal
Wood Post Guide in the bottom of the post. This step is only
applicable if your wood 4x4 post are embedded into the ground.
If your pergola is going to be installed on wood or concrete
surface, please dispose of this piece.
Using the vinyl weld glue insert the One-Way 4”x4” Internal
Wood Post Guide at the top of the post.
Guide the vinyl post over the wood post. The wood post
should stop about 67 1/2" above the ground or concrete patio.
This should allow the wood post to extend thru the One-Way
4x4 Internal Wood Post Guide at the top.
1
2
3
Center of Post
4
4
67 12“
Wood 4x4 Post