New England Arbors VA42062 - Manual (Page 16)

3
16
S T E P E I G H T
10 x 10 Flat Top Louvered Pergola
Insert the Louver Boards one by one. Make sure each board is
inserted completely into the brackets.
Attach the matching Pre-assembled Louver Bar. Pressure fit
the boards one by one.
Repeat for all six sub-sections. At this point, you should have
three full sections of Louvers as shown below:
Louver Assembly
2
2
www.newenglandarbors.com
3
The ends of the louver bars with large
space should be at the same end.
4
Do not attach with nuts at this point