Novak Atom and Cyclone ESC - Manual (Page 17)

CYCLONE & ATOM INSTRUCTION MANUAL 17
Before beginning this step, the speed control should be
connected to the receiver and to a charged battery pack
(4-10 cells for the Cyclone, 4-6 cells for the Atom), and the
transmitter should be adjusted according to Step 4.
1. TURN ON THE TRANSMITTER
2. TURN ON THE SPEED CONTROL
Slide the ON/OFF switch to the ON position.
3. With the transmitter throttle in the neutral position, press
and hold the ESC's 1-TOUCH button (One-Touch Tool
included) until the status LED turns solid red (approxi-
mately three seconds).
NOTE: If the 1-TOUCH button is pressed for fewer than 3 seconds, the
LED will blink red six times and you will need to start this process over.
4. RELEASE THE SPEED CONTROL’S 1-TOUCH BUTTON
5. PULL THE TRANSMITTER’S TRIGGER TO THE FULL
THROTTLE POSITION (Refer to Figure 12)
This must be done as soon as you release the 1-TOUCH
button to ensure that the speed control learns the Full
Throttle position. Moving the trigger gradually and/or
hesitating after releasing the 1-TOUCH button may cause
less than the Full Throttle position to be learned. Hold the
trigger there until the status LED turns solid green.
NOTE: The motor will not run during set-up even if it is connected to
the speed control.
6. PUSH THE TRANSMITTER’S TRIGGER TO THE FULL
BRAKE POSITION (Refer to Figure 13)
STEP 5: SPEED CONTROL SET-UP
Continued