Canon ImageCLASS D680 - Manual (Page 70)

8-1
T
roubleshooting
8
The following messages are displayed in the LCD when the machine performs a function or if it encounters an
error.
This section describes messages related to fax functions. For other messages
→ Reference Guide.
* The identification number does not appear in the standby display. It appears when scanning documents,
operating Fax Monitor or Memory Reference, or receiving faxes in Manual mode.
LCD Messages
Troubleshooting
Chapter 8
Message
CHANGE DOCUMENT
DOCUMENT TOO
LONG
HANG UP PHONE
MEM IN USE nn %
MEMORY FULL
NO TEL #
RECEIVED IN
MEMORY
TX/RX NO. nnnn *
Cause
When using the platen glass to send
documents with Book sending, you pressed
Start without changing the document.
The length of the document exceeds 356
mm.
The handset is not placed in the handset
cradle correctly.
Shows the percentage of memory
currently in use.
The memory becomes full during the
document scanning.
The one-touch speed dialing key or coded
speed dialing code you entered has not
been registered.
The machine received the fax in memory
because paper or toner ran out, or a paper
jam occurred.
When the machine sends or receives a
fax, it assigns a unique identification
number (nnnn).
Action
Place the next document on the platen
glass then press Start.
The length of the document should be
within 356 mm.
Replace the handset correctly.
Wait for the machine to send any faxes in
memory. Also, print or delete any
documents in memory you no longer need.
(
→ pp. 4-15, 4-16)
When sending the document, divide it
into a few parts or select a lower fax
resolution.
If you need more space, wait for the
machine to send any faxes. Also, print or
delete any documents in memory you no
longer need. (
→ pp. 4-15, 4-16)
If the machine’s memory becomes full
while scanning documents using the
ADF, the document being scanned stops
in the ADF. Press Set to make the
document come out automatically.
Register the one-touch speed dialing key
or coded speed dialing code.
(
→ pp. 3-2, 3-4)
Load paper in the cassette (
→ Set-up
Instructions), replace the cartridge
(
→ Reference Guide), or clear the paper
jam. (
→ Reference Guide)
Write the number down if you will need
it later.