Pro Boat PRB2450 - Manual (Page 13)

13
 3. With the radio system on, move the left
stick of your transmitter "down" to close
the sails. The sails should close, with the
jib sail being tighter than the main sail.
There should be some slack left in the sail
rigging when the sail gimbal moves the
sails in. There should also be enough
movement to turn on the motor switch
when the trim adjustment is moved to the
lower fully trimmed position.
 4. Bend the opening of each of the luft
rings after you have secured the main sail
to the mast, so they will not be pulled out
of the sail or from the mast.
Section 8 – Performance Tips
Replacement Parts
PRB2451. . . . . . . . . . . . . . . . . . . Hull only: Endeavor
PRB2452. . . . . . . . . . . . . . . . . . . Hatch: Endeavor
PRB2453. . . . . . . . . . . . . . . . . . . Mast Set: Endeavor
PRB2454. . . . . . . . . . . . . . . . . . . Boom Set: Endeavor
PRB3010. . . . . . . . . . . . . . . . . . . Motor: Endeavor
PRB2456. . . . . . . . . . . . . . . . . . . Drive Shaft Set: Endeavor
PRB2457. . . . . . . . . . . . . . . . . . . Plastic Parts Set: Endeavor
PRB2458. . . . . . . . . . . . . . . . . . . Rudder: Endeavor
PRB2459. . . . . . . . . . . . . . . . . . . Pushrod Set: Endeavor
PRB2460. . . . . . . . . . . . . . . . . . . Sails: Endeavor
PRB2461. . . . . . . . . . . . . . . . . . . Power Switch: Endeavor
PRB2462. . . . . . . . . . . . . . . . . . . Wiring Harness: Endeavor
PRB2463. . . . . . . . . . . . . . . . . . . Boat Stand: Endeavor
PRB2181. . . . . . . . . . . . . . . . . . . Screw Lock Pushrod Connector
PRB2183. . . . . . . . . . . . . . . . . . . Rigging Line Clips
PRB2186. . . . . . . . . . . . . . . . . . . Sail Luft Rings
PRB2187. . . . . . . . . . . . . . . . . . . Pushrod Nylon Clevis
PRB2188. . . . . . . . . . . . . . . . . . . Sail Boom Screw and Eyelet
PRB2407. . . . . . . . . . . . . . . . . . . Plastic Parts Tree
PRB2409. . . . . . . . . . . . . . . . . . . Rigging Line