Pro Boat PRB2450 - Manual (Page 3)

3
 1. Assemble the boat stand as shown and
use a wood glue or CA hobby glue to bond
the pieces together. Place the hull on the
stand.
 2. Slide the upper and lower mast halves
together.
 3. Slide the mast assembly into the fitting
on the top of the hull.
 4. Carefully unroll the sails from the mast.
The main sail will be attached to the top
of the mast at the crane. The jib sail
(front sail) will be attached to the front of
the crane as shown.
Section 2 – Rigging Installation
Section 1 – Inspection
Carefully remove the boat, boat stand and radio transmitter from the box. Inspect the boat
and make certain that no damage is present. If any damage is found, please contact the Pro
Boat retailer where the model was purchased.