Pro Boat PRB2450 - Manual (Page 8)

8
 1. Locate the jib stay on rigging lines "C"
and "D" on either side of the boat. Pull up
carefully on the jib stay to adjust the
tension so there is no slack in the line.
Work slowly and adjust both lines so the
main mast is completely vertical.
 2. Adjust the jib stay on the rigging line at
the bow "A" and stern "B" of the boat.
Tension the rigging lines so the mast is
perpendicular (square) to the hull of the
boat.
Section 4 – Adjusting the Rigging Cables
Install 8 AA alkaline batteries into the radio
transmitter, following the instructions for your
radio system. Carefully place the sailboat hull
into the included boat stand, if it is not
already there. Next, remove the radio box lid
(scale cockpit) of the boat carefully, as it is
secured by magnets at the rear of the
cockpit. Locate and charge the power battery
pack for 2-3 hours, closely monitoring the
temperature of the pack. If it becomes warm
to the touch, immediately end charging.
Confirm that the receiver switch is in the
"off" position and that the sail servo arm is
not touching the power switch. Connect the
power battery. Secure the battery to the
battery box with hook and loop material.
Warning : Do not charge the battery
overnight or on or near flammable
materials.
Note : The radio box lid has been
removed for photography.
Section 5 – Transmitter and Receiver Battery Installation