Pro Boat PRB2450 - Manual (Page 9)

9
Section 6 – Checking the Radio System
Turn on the radio system and test it to make
certain it is functioning correctly. First, turn
on the transmitter. Next, turn on the switch
that controls the receiver.
• Moving the right stick of your transmitter
will control the rudder. To turn to the right,
simply move the stick to the right, and the
rudder should also move to the right. Do
the opposite to turn left.
• Moving the left stick of the transmitter will
control the sails. By moving the left stick
upward, you will let the sails out. By
pulling the left stick down, you will tighten
the sails.
• Once the sails are pulled in, with the sail
control in the fully lower position, move the
sail trim adjustment toward the bottom of
the transmitter to operate the motor.
• Always extend the transmitter antenna
prior to sailing.
• When the radio system is working correctly
and the sails and fittings are properly
adjusted, you are ready to sail.
• After sailing, turn the receiver off before
turning the transmitter off.
Never sail with the sail trim adjusted to a
position that will allow the motor to turn on.
Note : The motor is for intermittent use
only. If you notice the power slowing,
stop motor use immediately and
recharge the battery. Continued use
will cause the radio system to lose
control.