Rev-A-Shelf SERVO-DRIVE uno - Manual (Page 2)

2
Using the installation instructions
Please read the installation instructions and safety information before SERVO-DRIVE uno
installation.
Safety
SERVO-DRIVE uno complies with current safety standards.
Nevertheless, there are certain risk factors if these installation instructions are not followed.
Please be aware that Julius Blum GmbH is not responsible for incidental or consequential
damages that may arise due to non-compliance with these installation instructions.
• All national standards must be followed for SERVO-DRIVE uno assembly. This includes,
in particular, those related to the mechanical safety of moving parts and electrical ca-
bling.
• The device may only be connected to a power supply that corresponds to the type and
frequency listed on the serial tag (see Blum plug-in power supply).
• The outlet must be freely accessible.
• No damaged parts should be used.
• Sharp edges may damage the cable.
• Neither the Blum plug-in power supply nor any cabling should come into contact with
moving parts.
• The total length of the cable should not exceed 2 m.
• Disconnect the mains plug before conducting any repair.
Danger of electric shock
➢ Never open a Blum plug-in power supply.
WARNING