If you want the good connection with s-video – Sceptre X32BV-NAGA User Manual
Page 30
SCEPTRE X32 HDTV User Manual
- 30 -
www.SCEPTRE.com
If You Want the Good Connection with S-Video…
1.
Make sure the power of X32 LCD HDTV and your set-top box is turned
off.
2.
Obtain an S-Video Cable. Connect the S-Video connector to both your
set-top box and AV’s S-Video connector port on the back of your X32
LCD HDTV.
3.
Obtain a RCA Audio Cable. Connect the white color connector to both
your set-top box and AV’s white connector port on the back of your X32
LCD HDTV.
4.
Connect the red color connector to both your set-top box and AV’s red
connector port on the back of your X32 LCD HDTV.
5.
Turn on the X32 LCD HDTV and your set-top box.
6.
Use the remote control’s source button or the source button on the right
side of the TV to switch to AV (S-Video).
Please Note :
•
Make sure the yellow connector in the same group is not connected.
You can only connect either the S-Video port or the Yellow Video
connector port. DO NOT CONNECT BOTH.
•
Please reference the set-top box’s manual as well, to make sure
the set-top box is configured to output correctly to the TV.
•
Sceptre’s X32 LCD HDTV supports SONY’s universal remote
code. Please look up SONY’s codes in your universal remote’s
hand book.