Soniclean UW3000 - Manual (Page 15)

9. Display Messages
These messages are displayed on the keyboard at various times. This
table explains their meanings.
Display Explanation
- - - -
Together with 5 beeps indicates that a process has
been completed. (The operator does not need to wait
for the beeps to complete before starting another
process.)
04.58* Shows the time remaining of the function that is
currently operating, i.e. clean or de-gas.
C-01* Indicates the current cleaning cycle number.
P-03* Indicates power level selected, e.g. P-02, P-03, etc.
dGAS Indicates the machine is de-gassing.
drn Machine is draining.
drnf Bottom of the wash tank is flushed with clean water,
and then drained.
FILL The machine is filling the wash tank.
OFF The machine has completed a drain or other operation
and needs to be turned off at power point.
END End of final clean.
Lid When the lid is in the open position, a flashing “Lid”
message is displayed, and all operations are paused.
When the lid is lowered again the paused operations
will recommence from the point of the pause.
tESt When the lid is open to maintain ultrasonic (foil/UPM)
performance test
Error messages
Drnb This indicates sensors detect liquid when wash tank
supposed to be empty.
FAIL Indicates that the operator programmed values have
been lost and will need to be re-programmed.
HOT Indicates an excessive heat condition.
LO Indicates a low level in the wash tank.
OFLO Indicates that liquid has been detected in an area of
the machine that should always be dry.
rtc Indicates the Real Time Clock (RTC) date/time in the
system is considered invalid. MRS function only
P-UP Indicates a clean process was interrupted and did not
complete the full cycle. Press ENTER to continue.
H2OL Indicates a water leak in the system or circuit/wiring
failure
IP-? Indicates the configuration of the machine is not
known. MRS function only
N.B. * Displayed when cleaning
UW-3000 Washer Operating Manual Page 15 of 24
© Soniclean Pty Ltd Version 2.0 April 2009