StarTech.com SV1108IPPWEU - Manual (Page 53)

Instruction Manual
46
User Station Filters
If any filters have been configured, they appear in the IP Filter and/or MAC Filter
list boxes.
IP and MAC Filters control access to the SV1108IPEXT/POW based on the IP and/or MAC
addresses of the computers attempting to connect. A maximum of 100 IP filters and
100 MAC filters are allowed.
To enable IP and/or MAC filtering, Click to put a check mark in the IP Filter Enable and/
or MAC Filter Enable checkbox.
If the include button is checked, all the addresses within the filter range are allowed
access; all other addresses are denied access.
If the exclude button is checked, all the addresses within the filter range are denied
access; all other addresses are allowed access.
Adding Filters
To add an IP filter, do the following:
1. Click Add. A dialog box similar to the one below appears:
2. Key the address you want to filter in the From: field. To filter a single IP address, key
the same address in the To: field. To filter a continuous range of addresses, key in the
end number of the range in the To: field.
3. After filling in the address, click OK.
4. Repeat these steps for any additional IP addresses you want to filter.
To add a MAC filter, do the following:
1. Click Add. A dialog box similar to the one below appears:
2. Specify the MAC address in the dialog box, then click OK.
3. Repeat these steps for any additional MAC addresses you want to filter.