Autopilot display, Gps signal status 4.1.1. autopilot not engaged – TruTrak Vizion 380-385 Operation Manual User Manual
Page 8
Vizion 380/385
8
Rev -‐ Initial
4. Autopilot Display
The autopilot display shows operating modes and associated
data.
It
is
also
used
to
display
setup
mode
screens
and
their
values.
When
displaying
operating
modes,
the
left
side
shows
lateral
data
and
the
right
side
shows
vertical
data.
4.1.
GPS Signal Status
4.1.1. Autopilot Not Engaged
The current GPS signal status is indicated in the top left corner of
the display. NO GPS is displayed when no valid signal is being
received. This is shown in Figure 4.1.1a
Figure 4.1.1a
A flashing period is displayed in the upper left when a GPS signal
is
detected
but
no
position
information
is
available
and
the
words
NO
FIX
are
displayed.
This
is
shown
in
Figure
4.1.1b
Figure4.1.1b
A flashing asterisk (*) and GPS OK is displayed when the GPS
position information is valid. This is shown in Figure 4.1.1c.
Figure 4.1.1c