Vexilar FL-22 - Manual (Page 17)

17
THE RIGHT HALF represents the entire
water column, from the transducer to the
bottom. Read the depth using the
inner red/white scale.
THE LEFT HALF represents the zoom
view. From the bottom up to six (or 12)
feet. Read the distance from the
bottom using the large
white scale.
Bottom
Fish
The Zoom scale reads in the
opposite direction as the full view
scale. The bottom will always be at the 7
O’clock position. Objects will appear above
this point. You can only see objects as far off the
bottom as the zoom setting permits, either 6 feet or 12
feet. Objects above this level will only appear on the right side
which show the entire water column.
FL-20 - Auto Zoom
IMPORTANT Zoom should be activated only when the transducer is submerged. If the
zoom is activated before the transducer is placed in the water, such as when moving from
ice fishing hole to hole while the zoom is operating, the bottom may not line up with the
zero mark on the zoom scale correctly. If this happens, simply switch the flasher to Normal
Mode, or Full View Mode, and then back to Zoom to reset the feature.
IMPORTANT If the depth of water changes while a zoom mode is selected, the bottom
position on the zoom scale will change accordingly. If the bottom signal moves off of
the display, reset the zoom by switching back to the Normal Mode momentarily. For this
reason, the Zoom Mode is not recommended for use on boats where changes in depth
are commonly occurring.
You interpret
the depth by
multipling the
indicated value
on the red/
white scale by
the multiplying
factor here.
20’ Range = 1x
40’ Range = 2x
60’ Range = 3x
80’ Range = 4x
300’ Range = 15x