Vexilar 107 Pro - Manual (Page 5)

INSTALLATION
You will need to find a place to mount the 107 Pro that
will make it easy to view and reach. You must provide the
unit with power and mount the transducer and sensor
assembly in an effective location.
MOUNTING THE UNIT
Find a convenient place to mount the unit. This may
include a boat seat, deck, dash, or a portable case. Make
sure that there is plenty of room for the unit to tilt freely
without the cables binding or stretching behind the unit.
Once you have found the spot, remove the unit from the
gimbal bracket. Securely attach the bracket to the mount-
ing surface. The screws provided are 5/8" long and are for
wood/carpet or dash mounting applications. An optional
removable swivel bracket is available.
CONNECTING POWER
Plug the 3 pin connector into the back of the unit. Find
the closest source of 12 volts and route the cord to it. Keep
the cord away from sharp metal edges and avoid tight
places where the cord may get crushed. Connect the white
wire to positive and the black wire to negative. If the cord
provided is not long enough, more can be added. Use 18
gauge wire minimum. Install the included 1 amp in-line
fuse, placed in the positive line, as close to the power source
as possible, to protect against shorts in the wiring.
5