Vexilar 107 Pro - Manual (Page 6)

MOUNTING THE SENSOR BOX
The sensor box needs to be located within three feet of
the main unit. It is recommended that it be fastened to a
sturdy surface. You can mount it, using the screws pro-
vided, to a flat surface or you can simply tie it to a frame
or wire harness, using cable ties which are not provided.
The sensor box is weather proof, but be sure to keep it out
of an area that may fill with water.
ASSEMBLING THE TRANSDUCER
Locate the transducer, and bracket hardware. This
includes;
1 Transducer
2 Angle Brackets
4 Bracket Screws
4 Washers
4 Nuts
4 Mounting Screws
Attach the bracket to the
transducer as shown in Figure 4. The flanges of the brack-
et normally point outward, away from the transducer. If
mounting space is tight, you can reverse the angle brack-
ets and face the flanges inward.
6
Figure 4