Vexilar LC-507 - Manual (Page 12)

12
ENTERING THE MENU
To enter the menu, press the MENU button. You will now
be on menu page 1. Press the MENU button again to get to
page 2. Press it a third time to get to page 3, the final menu
page. To exit the menu, press the MENU button a forth time. You
can also press any of the sonar control buttons (C-Line, Gain, or
Range) to close the menu.
ADJUSTING THE DISPLAY CONTRAST
While in the normal display mode, press the UP and
DOWN arrows to change the display contrast. Pressing
the UP arrow will increase the contrast and make the dis-
play darker. Pressing the DOWN arrow will decrease the
contrast and make the display lighter.
CHANGING THE MODE
There are three memory modes in which you can store three dif-
ferent control and feature setups. The number at
the bottom right corner of the display indicates
which mode you are in. When the unit is first
turned on, the mode should be set to 1. Pressing
the LEFT or RIGHT button will move you through
the modes. If the current mode is 1, and you press the RIGHT arrow
button, the mode will change to 2. Press it again to move to mode
3. Pressing the RIGHT arrow button, again, will move you back to
mode 1.
How each of these modes are setup is entirely up to you. Instead
of having to change several control and menu functions, you sim-
ply move to the next mode, which you have previously set up. There
is more information regarding the Mode feature in the section
“Typical Indications” starting on page 20.