Cub Cadet 7532 - Manual (Page 117)

MAINTENANCE/ADJUSTMENTS
109
Rotating fan and belts. Contact can injure. Keep clear.
RAISE STOP SETTING POSITION
If raise stop setting position is incorrect,
the hydraulic pump might be damaged.
Therefore carefully adjust as below.
1. Disconnect an implement from the hitch. (See Disconnecting Implement
from Hitch in this manual.)
2. Disconnect LH and RH lifts rods from the lift arms.
3. Start the engine.
4. Move the hitch control lever rearward to raise the lift arm to the
maximum lifting position.
5. With the arm so raised, stop the engine.
6. Check a free play of the lift arm to be 5 to 10 mm at the tip of the lift
arm by hands.
7. If the insufficient free play is available, move the raise stop forward
and check again with the same procedure as before.
HITCH CONTROL HITCH CONTROL
LEVER
LEVER
HITCH CONTROL
LEVER
RAISE
STOP