Cub Cadet 7532 - Manual (Page 78)

TIRES/WHEELS/SPACING/BALLAST
70
Toe-in Adjustment
TO CHECK THE TOE-IN, USE THE FOLLOWING PROCEDURE:
1. Put the tractor on level ground and the wheels in the straight-ahead
position.
2. Place chalk marks at points A on the centerlines of both front tires at
the same height as the centerline of the hubcap.
3. Measure the distance (L
1
) between the chalk marks at points A.
4. Move the tractor forward a distance equal to one-half revolution of the
front
wheels.
5. The chalk marks will now be at points B. Measure the distance (L 2 )
between the chalk marks at points B.
6. The figure of L 1 minus L 2 is the toe-in. Make sure the toe-in is adjusted
properly. If not, adjust the toe-in.
FRONT AXLE TYPE
MFD
TURN THE WHEELS
ONE-HALF
REVOLUTION
TOE-IN (L 1 -L 2 )
0 TO 0.20 INCH (0 TO 10 mm)
L 2 L 1
A B
A B
A B