Cub Cadet 7532 - Manual (Page 65)

FIELD OPERATION
57
THREE POINT HITCH SYSTEM
The three point hitch system gives position control and draft control (If
equipped) of implements. This tractor is equipped with a category I hitch.
The three-point hitch dimensions are shown in the following table.
Implement Identification
Dimensions
A – Gap in top of implement mast
B – Diameter of holes in top of
Implement mast
C – Diameter of hitch pins
D – Lower Hitch Pin
Inner Shoulder Spread
Cat I
Implement
44.5 mm (1-3/4 inch)
19.1 mm (3/4 inch)
22.2 mm (7/8 inch)
682.6 mm (26-7/8 inch)