Chaparral FS2620R - Manual (Page 24)

FS2620R Rack Model User’s Guide
2-8
To make the host FC connection:
1 Connect the Fibre Channel cables to the router and the host computer/hub/ switch.
You can use one or both FC connections. If only one connection is used, disable the
unused FC connection. For information about disabling a channel, see
Configuring
the FC Host Channels on page 3-12 .
2 Power up connected servers, hubs, or switches on the network if necessary.
You are now ready to configure the router. To view the default settings, see Router Default
Settings on page 2-10 . For information about changing the default settings, see Chapter 3,
Configuring the Router .
Understanding the LED Status Lights
LED status lights are on the rear panel of the router. For information about
troubleshooting problems indicated by the status lights, see
Chapter 4, Troubleshooting .
Figure 2-4. LED status lights
Table 2-2 describes the meaning of the LED status lights located on the rear of the router.
Table 2-2. LED status lights
LED
Label Description Color Function
FT Router fault Red Solid on when router is powered-up and
fails any internal diagnostic or detects a
critical error
ST Router status Yellow Solid on when router is powered-up and
passes all internal diagnostics
Yellow Solid off when router either:
!
Detects a warning/degraded mode
!
Fails to boot