Chaparral FS2620R - Manual (Page 95)

I-3
upgrading firmware 3-37
FT light 2-8
fuse, replacing 4-5
G
gateway 3-6
GBICs, compatible types of 2-5
H
Hardware Information screen 3-34 , 4-6
hardware information, displaying 3-32
Host Configuration screen 3-14
I
initial Router Administrator screen 3-2
initiator ID, changing for router 3-17
installing
example configurations of 2-11
in a rack 2-2
on a desktop or table 2-2
the router 2-1
L
LED lights 2-8
LED status lights 2-8
lights 2-8
Link Speed screen 3-15
LK light 2-9
Loop ID
changing for router 3-12
settings for 3-12
SOFT setting 3-12
Loop ID screen 3-15
Loop ID to AL_PA mapping A-2
LOOP topology setting 3-12
LUNs
changing for devices 3-25 , 3-27
changing for router 3-12
displaying for router 3-36
NONE setting 3-12
settings for 3-12
SOFT setting 3-12
LVD model 2-4
M
MAC hardware address B-1
map
displaying FC-to-SCSI address map 3-28
FC-to-SCSI addresses A-1
Loop ID to AL_PA A-2
mapping mode
AUTO setting 3-24
changing 3-24
FIXED setting 3-24
Mapping Mode screen 3-25
N
navigating in the Router Administrator software 3-9
Network Management System Console
SNMP Configuration screen 3-7
System Configuration screen 3-6
TCP/IP Configuration screen 3-6
Network Management System Console screen 3-4 , 3-5 ,
3-7 , 3-8
NONE setting 3-12
P
packing list 2-1
password
entering 3-4
Password screen 3-4
physical address B-1
POINT-TO-POINT topology setting 3-12
powering down
devices 2-7
the router 2-7
powering up
devices 2-7
the router 2-7
Problem 4-4
problems
during bootup 4-1
router not responding 4-5
with COM port 4-4
with device SCSI channel 4-5
with terminal emulator 4-4
with terminal screen 4-4