Chaparral FS2620R - Manual (Page 97)

I-5
Address Mapping 3-24
Alarm 3-22
Change Address Map 3-26
Channel 3-18
Channel Configuration 3-17
Configuration Menu 3-13
Display Address Map 3-26 , 3-29
Display Devices 3-28
Enabled/Disabled 3-14
Event Log 3-30
Event Log Menu 3-30
Flash Utility 3-38
Hardware Information 3-34 , 4-6
Host Configuration 3-14
initial Router Administrator 3-2
Link Speed 3-15
Loop ID 3-15
Mapping Mode 3-25
navigating in 3-9
Restore Defaults 3-23
Router LUN 3-16
Scan Configuration 3-21
Set Date 3-19
Set Date/Time 3-19
Set Time 3-20
System Menu 3-2 , 3-8
Utilities Menu 3-34 , 4-6
SCSI channels
changing mapping mode 3-24
connecting to 2-4
LVD 2-4
problems with 4-5
single-ended narrow 2-4
Ultra2 wide 2-4
SCSI devices
changing addresses of 3-25 , 3-27
changing FC LUNs of 3-25 , 3-27
displaying 3-27 , 3-28
SCSI ID, changing for router 3-17
serial port 2-6
connecting to 2-6
problems with 4-4
serverless backup 1-4
Set Date screen 3-19
Set Date/Time screen 3-19
Set Time screen 3-20
setting
FC channel speed 3-13
setting up the router 3-1
settings
for the RS-232 port 2-6
settings for 2-6 , 3-12
shutting down the router 3-23
SNMP Configuration screen 3-7
SNMP trap 3-8
SOFT setting 3-12
software
accessing to configure the router 3-1
navigating in 3-9
specifications 1-5
speed
setting for FC channels 3-13
ST light 2-8
status lights 2-8
support 4-1
System Configuration screen 3-6
System Menu 3-2 , 3-8
T
table, installing the router on 2-2
TCP/IP
configuring the router B-1
TCP/IP Configuration screen 3-6
technical support 4-1
Telnet
accessing Router Administrator software 3-5
temperature, alarm thresholds for 3-22
terminal
screen problems 4-4
terminal emulator software 3-1
terminal emulator, problems with 4-4
terminal screen problems 4-4
time, changing for router 3-19
topology
Auto Detection setting 3-12
LOOP setting 3-12
POINT-TO-POINT setting 3-12
selecting 3-12
troubleshooting
COM port 4-4
device SCSI channel problems 4-5