Simple network management protocol configuration – Chaparral FS2620R User Manual
Page 85
Simple Network Management Protocol Configuration
B-3
To discover which IP address was assigned to the router:
1
Follow the steps above for ARP to bind the router MAC address to a temporary static
IP address.
2
Use the command arp –g to display your computer’s the IP-to-MAC address table.
This table contains two entries corresponding to the router MAC address. One of the
entries contains the temporary static IP address you just bound to the router MAC
address, and the other entry is the DHCP-assigned IP address. You can use the
DHCP assigned address to access the router from any computer on the network.
Simple Network Management Protocol
Configuration
Remaining TCP/IP parameters, such as Simple Network Management Protocol (SNMP)
traps, can be configured after the TCP/IP configuration is done. Ask your system
administrator to configure these parameters according to the requirements of your LAN.
For more information about SNMP implementation, contact Chaparral regarding SNMP,
or visit our Web site at
.
❒