Winco GM100 - Manual (Page 8)

6. Engine Pre Alarms & Alarms
The controller monitors engine oil pressure, engine temperature and engine
speed directly using sensors. If measured parameters become out of
tolerance, the controller will begin to prealarm the specific condition. If the
parameter exceeds the fault values, the controller will open the run signal
causing the engine to shutdown.
6.1 Engine Pre Alarms
6.1.1 In the case of an engine pre alarm, the yellow LED will illuminate.
6.1.2 The engine will continue to run.
6.1.3 If the out of tolerance value is one of the full time display items, the
number will flash every second on the display. (Defaults shown
below)
•
Low Fuel Level < 20%
7