Winco GM100 User Manual
Page 9
Advertising
6.2 Engine Faults
6.2.1 In the case of an engine alarm, the red LED will illuminate.
6.2.2 The controller will open the run circuit causing the engine to stop.
6.2.3 A fault message will be displayed indicating which parameter
caused the controller to stop the engine. (Defaults shown below)
•
Low Oil Pressure > 15 PSI for 5 Seconds
•
High Engine Temp < 225 F for 5 Seconds
•
Low Fuel Level < 1% for 5 Seconds
•
Over Speed < 67.0 for 1 Second
•
Over Crank
6.2.4 The control panel will keep this message displayed unit a manual
reset done by placing the Auto / Off / Run toggle switch back in the
OFF position.
6.2.5 A fault will also be cleared if a power cycle occurs.
8
Advertising