Winco Mfg. 2588 - Power Designer Blood Drawing Chair - Padded vinyl - Manual (Page 10)

10
Models 2578 Seat Height Set-up and/or Adjustment
The seat height of your 2578 Designer Blood
Drawing Chair can be adjusted during setup.
CAUTION: The Seat Assembly is VERY
HEAVY. To adjust the height; the chair must
be supported by someone that can LIFT
OVER 50 LBS.
1. Use two people; Use the included 3/16”
Hex (Allen) wrench and the included
“multi-size” wrench to remove the nut,
lockwasher & shoulder bolt from the
square post on the Base Assembly.
2. Align the Seat Bracket over Seat Post.
3. IMPORTANT: Have your helper grasp the
WARNING
CHAIR MUST NOT BE USED WITHOUT SHOULDER BOLT,
LOCKWASHER AND NUT COMPLETELY TIGHTENED
– INJURY COULD RESULT –
seat by the metal seat frame to hold the Seat Assembly
steady to prevent it from dropping;
4. Slowly lower the Seat Bracket down onto the Seat Post
until the hole in the Seat Bracket is aligned with a hole
on the post for the desired seat height. Re-install the
shoulder bolt and locknut into one of the aligned sets of
holes to obtain desired seat height.
TIGHTEN THE NUT & LOCKWASHER ON SHOULDER
BOLT
SEAT HEIGHT ADJUSTMENT: Follow ALL safety instructions outlined in this manual.
1. Plug power cord into a properly grounded wall outlet. (SEE PG. 5)
2. Press foot down on foot control arrows to raise or lower chair to desired height.
Chair will stay at the adjusted height when foot control is released.
Models 2588 Seat Height Adjustment Instructions