Winco Mfg. 2588 - Power Designer Blood Drawing Chair - Padded vinyl - Manual (Page 9)

9
Cabinet Assembly Models 2570, 2572, & 2574
1. Remove the drawer from the cabinet.
2. Attach the Welded Cabinet Support to bottom of Cabinet by installing (4) 2” screws through (4) holes in the Welded
Cabinet Support. Install washers and locknuts on the screws inside the cabinet. (FIG. 1).
3. Use the supplied wrench to hold nuts inside of cabinet & tighten screws with a Phillips scredriver.
4. Cabinet installs on LEFT side of chair: Use “Arm Assembly” Instructions (from previous page) to install the Cabinet
Support & Cabinet to chair frame. See (FIG. 2) below and “Arm Installation” section on previous page.
5. Reinstall Drawer.
6. Adjust the Cabinet to desired height and tighten Knob.
7. CABINET INSTALLATION COMPLETE. (FIG. 3).
BE SURE to tighten the black knob to secure the cabinet - even if no height adjustment is made. This will secure
cabinet for use.
Special note for chairs with “PR or P2” option:
If your chair was ordered with a “PR” (Pivot Arm option) then you are fi nished with the Cabinet install. Otherwise pro-
ceed to “PR & P2” Installation Instructions on Page 12.
FIG. 1 FIG. 2
FIG. 3