Winco Mfg. 2588 - Power Designer Blood Drawing Chair - Padded vinyl - Manual (Page 7)

7
Seat Installation 2570-2575, 2578, 2588
Models 2570 and 2571
(FIG. 1)
1. Position Chair Frame in upright position. Check tight-
ness of all installed screws, bolts and nuts in case they
loosened during shipping.
2. Align the mounting holes on the plastic Seat with the
Seat Support holes. Hole spacing of Seat and Seat
Supports will be narrower toward front of chair. Seat can
only be installed facing one direction. FIG 1
3. Using the included wrench (or your own 5/16” tool), install
the (4) 705300 Seat Screws through the holes of Chair
Frame, and into the four (4) holes on bottom of the plastic
Seat. Make sure screws are completely tightened. FIG 1
NOTE: These “special” screws MUST BE USED for maximum grip in
this seating application. They can be slightly diffi cult to “get started” in the
holes on the plastic Seat.
TIP: Use even pressure and, if available, a “5/16” nut-driver” (screw-
driver-type handle with a 5/16” socket on end) however, this task can be
accomplished with the included wrench.
WARNING
Failure to completely tighten the seat mounting screws
COULD RESULT IN SERIOUS INJURY.
Models 2572, 2573, 2578, 2588
(FIG. 2)
1. Position Chair Frame in upright position. Check tightness
of all installed screws, bolts and nuts in case they loos-
ened during shipping.
2. Align the screws on bottom of the Seat Assembly, with
the Seat Support holes. (Hole spacing of Seat Supports
will be narrower toward front of Chair). Seat can only be
properly installed facing one direction. Be sure that all
(4) Seat Screws go completely through the Seat Support
straps on chair frame.
3. Install (4) lock nuts to the screws on the Seat Assembly
and completely tighten with 7/16” wrench.
Models 2574 and 2575
(FIG. 3)
1. Position Chair Frame in upright position. Check tight-
ness of all installed screws, bolts and nuts in case they
loosened during shipping.
2. Align the screws on bottom of the Seat Assembly, with
the Seat Support holes. FIG 3
NOTE: Seat Supports are angled to give the seat a
very slight recline angle. The FRONT of seat should be
positioned toward the HIGHER end of the strap. FIG 3
Be sure that all (4) Seat Screws go completely through
the Seat Support straps on chair frame.
3. Install (4) lock nuts to the screws on the Seat Assembly
and completely tighten with 7/16” wrench.
FIG. 1
FIG. 2
FIG. 3