Winco Mfg. 6240 - Inverness 24 Hour Treatment Recliner - Manual (Page 14)

Copyright 2014, WINCO MFG., LLC 14
GENERAL MAINTENANCE
GAS SPRING RELEASE ADJUSTMENT:
If recline levers fail to operate properly, adjust the gas spring using the
instructions below.
1. Open swing-arms, lift safety aprons and remove (4) wing-nuts from seat
mechanism. (2 on either side of chair)
WARNING:
•
ENSURE heating wire for seat is clear of all moving parts of the
mechanism during installation.
• UNPLUG power cord from power source BEFORE cleaning.
2. Chair WITHOUT Heat & Massage:
a. Lift seat off of mechanism and set aside.
Chair WITH Heat & Massage:
b. Lift seat off of mechanism and position it as shown (2b).
IMPORTANT:
•
Seat is tethered to chair frame. Do not forcefully pull on seat
• Chairs equipped with heat and massage - DO NOT attempt to
unplug wires.
3. Locate the gas spring and loosen the nut on the gas spring using an
11/16" wrench.
4. Remove the opposite end of gas spring by removing the cotter & clevis
pin.
Proceed to step 5 or 6 depending on the necessary adjustment.
IMPORTANT:
•
DO NOT allow button on end of cylinder to depress while performing
this task or gas cylinder will extend fully and become impossible to
reinstall on chair.
3
1
4
2b