Winco Mfg. 6240 - Inverness 24 Hour Treatment Recliner - Manual (Page 6)

Copyright 2014, WINCO MFG., LLC 6
6
ASSEMBLY INSTRUCTIONS
BACK ASSEMBLY INSTRUCTIONS:
5. Slide the back onto the recline mechanism until the middle hole of
the mounting bracket (A) is aligned with the middle hole of the recline
mechanism (B).
6. Install knobs (tethered to back) and tighten to a secure fit.
7. Ensure that the rear apron rests OVER the rear brace of chair.
IMPORTANT:
•
Test to ensure the back has been properly installed by pulling up on
the back's push handle. The back should remain securely in place.
5
7