Sears KENMORE 385. 1254180 - Manual (Page 34)

SECTION 3. LEARN THE STITCHES
Zigzag Stitches (Continued)
o Monogramming o Embroidery
Set the Machine
Stitch setecior
VVi 4 ,|
Top thread terwon
control 1 to A
Stitch length
0to24
Satin stitch foot
Here's How
1. Set the same as satin stitch,
2. Back the fabric with paper or
interfacing.
3. Draw the design on to the fabric
wtth tailors chalk.
4. Satin stitch, adiustsng the stitch
width as necessary to form each
pattern.
5. If usmg paper, carefully remove it
when you have finished sewing.
32
1. Put the darning plate over the nasdie
plate issa p. 27j.
2. Remove presser foot.
3. Adjust the stitch width as desired
¡see p. 20).
4. Draw the design on to the fabric with
tailor's chalk.
B. Stretch the fabric between
embroidery hoops and place under
the needle,
6. Lower the presser foot lever to
engage the top thread tension.
7. Holding the top thread in your left
hand, rotate the hand wheel toward
you one complete turn.
Pull the top thread to draw the
bobbin
thread through to the
surface of the fabric.
8. Using a medium speed, stitch along
the marked outline, guiding the
fabric carefully by hand.