Lighting, Awarning, Lighting -23 – Sears POWER MISER 153.335914 User Manual

Page 22: Operating instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating Instructions

Lighting

AWARNING

BEFORE LIGHTING [PROPANE (L.P.) GAS WATER
HEATERS]: Propane (LP.) gas is heavier ^an air. Should there
be a leak in the system, the gas will settle near the ^ound.
Basements, crawl spaces, skirted areas under mobile homes
(even when v«ttilat^, closets and areas below ground level will
serve as pockets for the accumulation of this gas. Before
attempting to light or relight the water heater^ pilot or turning
on a nearby electrical light smtch, be absolutely sure there is no
accumulated gas in the area. Seardt for odor of gas by sniffing at
ground levd in the vicinity of the appliance. If c^r b detected,
follow steps indicated at "For Your Safety" on the cover page of
this manual then leave the premises.

Lighting and operating instructions are located on front of the
water heater, above or to one side of the gas control valve.

AWARNING

AN ODORANT IS ADDED TO THE GAS USED

BY THIS WATER HEATER.

FOR YOUR SAFETY
IF YOU SMELL GAS:

• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in

your building.

• Immediately call your gas supplier from a neighbor^ phone.

Follow the gas suppliei^ instructions.

• If you cannot reach your gas supplier, call the fire depart­

ment.

AWARNING

DO NOT force the gas control Imob. Use only your hand to
push it down to light the pilot, or to turn it to “ON”, “OFF”
or “PILOT”. Never use a tool such as a lever, wrench or pli­
ers. Do not hit or damage the knob. A damaged knob may
result in an explosion and serious injury. If you have problem
turning the knob, call the gas supplier immediately.

CHECK FOR LEAKS

Be sure to check all your gas pipes for leaks before lighting your
water heater. Use a soapy water solution, not a match or open
flame. Check the factory gas fittings after pilot is lit and gas con­
trol knob is still in “PILOT” position. Then, check the fittings
when the main burner is turned “ON”. Use a soapy water solu­
tion for this, too.

Figure 9

Figure 10

Figure

Figure 12

INNER DOOR

OUTER DOOR

22

Advertising