Winding bobbin – SINGER W106 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
02/14/2008
WINDING BOBBIN
Disengage the hand wheel(l) from
the stitching mechanism by turning
the clutch nut (2) toward you or
ccwnter-clockwiM.
Place a spool of thread on one of
the spool pins and lead thre«f
through
the
Top
Thread
Guide
(3) and Bobbin
Winder tension
Disc at the right front of bedplate.
Run the end of thread through a
hole in the bobbin edge and place
tobbin on spindle of bobbin winder
fitting the notch on bobbin over
small pin on spindle.
Prea
bobbin
winder
latcfi
(4)
down, and hold the thre^ end
loosely then start machine slowly,
and bobbin winder latch will be
relea^
to
stop
winding
when
bobbin is full.
Turn clutch nut away from you
until sewing mechanism is again
engaged so that needle moves when
you turn the hand wheel.
Break off loose thread end used to
start the winding and cut other
thread end. Then remove bobbin
from bobbin winder.